|
|
New User
Posts: 4
Location: Tombstone az | I have 99 sundowner 4 horse living quarters. The jack is a standard 10 or 12 k with an 12 volt electric motor on an adapter. There is a small gear that screws to the motor and runs the gears to the jack. The screw slipped and wore out the splines. I have called sundowner parts and they said to call redneck trailer supply. Redneck said to call the motor manufacture. The motor manufacture said they just build the motors. I have called all the local trailer parts stores. No luck. Can anyone tell me where to get this part? Any help is welcome. Thanks in advance. |
|
|
|
Veteran
Posts: 133
Location: NC | most electric jack are installed by the LQ places believe it or not. so I would check with the conversion company that put your LQ in. |
|
|
|
New User
Posts: 4
Location: Tombstone az | I finally found the part at a company called Factory Direct equipment. It is an Equalizer part called a pinion gear. Yahoo success at last. |
|
|
|
Veteran
Posts: 211
Location: El Paso, Texas | Spend the money and replace it with an hydraulic jack. Much better in the long run |
|
|
|
New User
Posts: 4
Location: Niles, Mi, 49120 | I Agree wit El Paso Bob. |
|
|
|
New User
Posts: 4
Location: Niles, Mi, 49120 | I Agree with El Paso Bob. |
|
|
|
New User
Posts: 4
Location: Tombstone az | Cost me $35 for the part and shipping. That was a whole lot easier to swallow than $1200-1400 for a hydraulic jack. |
|
|
|
Expert
Posts: 3853
Location: Vermont | Originally written by Az rancher on 2015-03-26 9:08 PM
Cost me $35 for the part and shipping. That was a whole lot easier to swallow than $1200-1400 for a hydraulic jack. Congrats on finding a part...now if it fails again...then you might want to look at a bigfoot...:) http://shop.thebigfootleveler.com/1pt-Manual-Override-Landing-Gear-... |
|
|